Flat vertex ridge

Element for joining the pitches, both apex and diagonal. It is laid by overlapping the sheets on both two-pitch roofs and hip-roofs.

Notched, hinged ridge

It can be used on the apex of the two pitches, its notched shape ‘closes’ the corrugations and as it consists of two pieces, laying is more even still because it can be adapted to the different pitch slopes.

Vertex ridge, notched and ventilated

Element for joining the pitches, both apex and diagonal. It is laid by overlapping the sheets, both on two-pitch roofs and hip-roofs.

Universal diagonal ridge capping

Element for joining the pitches, both apex and diagonal. It consists of a central part and two microcorrugated lateral water guards in a special material that can be manually adapted to any corrugation shape, whatever the slant or angle.

Ventilated diagonal ridge

Wall connection

Connecting component between a vertical wall and the roof pitch. It has its own water guard for coupling with the sheet which has the same shape to match the Coppo profile

Ventilated wall connection

Connecting component between a vertical wall and the roof pitch. Besides having ventilation outlets, it also has its own water guard for coupling with the sheet which has the same shape to match the Coppo profile.

Snow stop

This element protects against the falling of snow that has collected on the roof. Available in copper, aluminium and prepainted steel

Corrugation closure

Metal head closing element for the IsoCoppo Piano panels.

Polycarbonate sheet

Thermoformed component in transparent compact polycarbonate. Dimensions 1340 mm x 1039 mm.

Skylight base in fibreglass

Fibreglass monoblock with external edge joining the Coppo sheet.

Polycarbonate dome for the skylight

Passage element for inspection on the roof or to illuminate the room below. Monoblock, opened by hand or electrically. Upon request it can be supplied with a double frame acting as a smoke vent.

Chimney converse base in aluminium

Pressed metal component in aluminium with external edges joining the Isocoppo profile

Converse base in stainless steel

Pressed metal component in stainless steel with external edges joining the Coppo/IsoCoppo profile.

Under corrugation seal

Polyethylene element with a cross section shape of the tile profile that goes under the sheet.

Comb bird screen for ventilated roofs

Comb shaped element in PVC. It can be supplied in aluminium and copper. Specific for ventilated roofs.

“Semmler” expansion joint

This element compensates for the expansion of materials, necessary for gutters or converses more than 10 m in length. Available in aluminium and stainless steel.

Drill fixings

"Alublok" system for fixing sheets or panels on wooden structures. Available in steel or prepainted stainless steel with a tile red colour.

Self-tapping fixings

"Alublok" system for fixing sheets or panels on metal structures. Available in steel or prepainted stainless steel with a tile red colour.

Batuband sealing tape

Sealing tape for joining nodes.

"Alusik" silicone

"Alusik” silicone cartridge: various colours.

Coppo red spray can

Spray colour can for touching up.

“Alupermo” breathing sheath

A particular synthetic, breathable and waterproof film. In short, it lets any steam through from inside while it is impermeable to external agents like humidity, rain, etc. It is particularly suitable for application on ventilated roofs to protect the insulating layer where impregnation would cause the insulating power to deteriorate. Roll height cm. 150 (70 m rolls).